TM Desana Max CL g 35

IT‘S THAT EASY 1. DISSOLVE POWDER Always rinse the cleaning container! Dissolve the contents of a TM DESANA MAXcl sachet in luke warm water (up to 35° C) and fill the container with water. 2. SHAKE: SOLUTION IS PURPLE Close container and shake 3 times! Pull a sample of the original solution. Freshly prepared solution is PURPLE. 3. CONNECT CLEANING CONTAINER Connect the tap head of the beverage container under CO2 pressure to the cleaning container. 4. FILL THE CIRCUIT Open the taps until the cleaning solution flows out of the tap. 5. LET IT SOAK FOR 10-20 MINUTES, SOLUTION TURNS GREEN Close the tap. Let the TM DESANA MAXcl cleaning solution soak in the lines during other maintenance work (for about 10-20 minutes). During this time, TM DESANA MAXcl dissolves hard to remove soiling in the lines and turns GREEN. REPEAT PROCEDURE Repeat steps 4 and 5 - for 3 minutes of exposure time - until the cleaning solution no longer turns GREEN. PURPLE MEANS CLEAN! If the solution from the lines shows the same colour as the original (colour comparison with sample of the original solution) after 3 minutes, the lines are in perfect hygienic condition. Done! 6. RINSE WITH DRINKING WATER Rinse with pure drinking water: 200-1000ml water per meter for 7mm pipes (see study by the University of Vienna, 05-02-2003). Check the rinsing by means of pH test strips: The pH value of the rinsing water must correspond to the pH value of the fresh water.